Read the What's
New page for the latest updates.
The new FAQ (Frequently asked
questions) section is under construction.
If you would like to create a link to this site,
follow the directions on this page. Link 2 Us
Progress has been slow on my new buggy engine,
but I've put together a lot of information on how to
install a Turbocharger and Fuel Injection.
|
|
| |
Top : Tech Tips : Carburetors
Links:
GASOLINES - TECHNICAL REVIEW
- GASOLINES - TECHNICAL REVIEW There has always been a big question in many racers minds ...what is gasoline? what is in it? how and why does it work? Hopefully this article, which are simplified versions of papers produced...
(Added: 18-Dec-2000 Hits: 1361 )
|
Adjusting your Kadrons
- How to adjust: Mixture Idle Accelerator Pump linkage How to change: Main Jetting and needle valve Idle Jets Venturie. What Kadron fuel filter?
(Added: 16-May-2002 Hits: 2164 )
|
Home Grown EGO Sensor Meter
- Make your own O2 meter. Here is my version of an LM3914 driven display for an EGO sensor (O2 sensor, lambda sensor). It uses the bar mode of a 3914 and is scaled from 0 V to 1 V, so all ten LEDs are in use.
(Added: 30-Sep-2000 Hits: 3613 )
|
AutoSpeed - AutoSpeed Needle Mixture Meter - Part 1
- A pre-built analog LCD meter that you can easily connect to your car's oxygen sensor, and just as easily mount on the dash. Then you can see when the engine's mixtures are rich, lean or in closed loop.
(Added: 28-Sep-2001 Hits: 1088 )
|
AutoSpeed - DIY Detonation Detection, Part 1
- Sensing when an engine is detonating has become more and more important in recent years. In older cars, the reduction in the lead content of fuel has meant that detonation is more likely to occur - especially when the comp ratio is wound up to give good performance. In factory turbo engines, dramatically increased boost means that detonation is very probable. Build an inexpensive detonation microphone with these instructions.
(Added: 28-Sep-2001 Hits: 2065 )
|
Aircooled.Net, Inc. - Jet Your Carburetor
- People often go right ahead and spend $500 for a set of carburetors, bolt them on, and seem "pleased" with the results. Others are upset by a backfiring, or smoke belching monster. In either case, spending the time to properly jet a set of dual (or single) carburetors is a very worthwhile task, since recieving a "perfect out-of-the-box" carburetors is one of the biggest myths in the VW industry!
(Added: 19-Dec-2000 Hits: 4001 )
|
Related Categories:
Pages Updated On: 5-Apr-2008 - 01:02:40
|
